Absorbing material, Shielding material, Electromagnetic shielding, Magnetic sheet, ferrite sheet.
News Center
Your present position:Home-News Center-How is the electromagnetic shielding room installed? Back >

How is the electromagnetic shielding room installed?

Author:admin   AddTime:2021-05-04

How is the electromagnetic shielding room installed? There are four main installation methods, including: pushing method, knocking method, pulling method, and thermal dismantling method. How much do you know about the four installation methods of electromagnetic shielding rooms, let us tell you about them below.

1. Push method
Use a press to push the bearing to work smoothly and reliably without damaging the machine and the bearing shielding machine room. The press has manual push, mechanical or hydraulic press.

2. Percussion method

The percussive force is generally applied to the inner ring of the bearing. The percussive force of the shielded machine room should not be applied to the rolling elements and cages of the bearing. This method is simple and easy to do, but it can easily damage the bearing. When the bearing is at the end of the shaft, use less than the bearing. The inner diameter of the copper rod or other soft metal material is against the shaft end, and the bearing block is added under the bearing, and it can be removed by tapping it with a hand hammer. In applying this method, attention should be paid to the proper placement of the cushion block and the correct focus point.



Three, pull out method
With special puller, when disassembling, as long as the handle is rotated, the bearing will be slowly pulled out. When removing the outer ring of the bearing, the corners of the two legs of the puller should be opened outward; when removing the inner ring of the bearing, the two legs of the puller should be inward and stuck on the end face of the inner ring of the bearing.

Four, hot demolition method
Used to disassemble tightly fitted bearings. First, pour the engine oil heated to about 100°C on the bearing to be dismantled with an oil can, and after the bearing ring is heated and expand, the bearing can be pulled out with a puller.
This is about the four installation methods of electromagnetic shielding machine room bearings. The specific method to use depends on the specific situation.

Absorbing Material:https://www.goodsmaterial.com/

Related Articles
The high permeability of shallow of absorbing materials plant absorbing material application

The high permeability of shallow of absorbing materials plant absorbing material application

2021-05-04

First of all, let's see what is high permeability absorbing material: high permeability refers to the…

Analysis of three functions of flexible Ferrite separator on wireless charging Coil in Absorbing Material factory?

Analysis of three functions of flexible Ferrite separator on wireless charging Coil in Absorbing Material factory?

2021-05-04

I have written a lot about the role of ferrite tablets before. Today, I will summarize the three main…

Here are five common NFC ferrite tablets on the market

Here are five common NFC ferrite tablets on the market

2021-05-04

Follow the footsteps of xiaobian, today summarized the next market common in 5 NFC ferrite tablets, I…

Leave A Message

Just tell us your requirements, We can do more than you can imagine.

Links: Bluetooth Speaker Passive Speaker Wooden Speakers USB Microphone

Shenzhen jingju technology co., LTD., all rights reserved ©2020
Hot Products:ferrite sheet | shielding material | electromagnetic shielding | magnetic sheet | amorphous nanocrystals